Tradeflex Kft
Digital Sine Wave Inverter IVT DSW-2000, 12 V, 2000 W
-True sine wave alternating voltage 230 V/50 Hz
-High peak output power 4000 W
-Galvanic isolation
-Power-saving standby and sleep function
-Dynamic deep discharge protection
-Power start function for loads with high start-up current
-Power and temperature-controlled fan
-Over-voltage switch-off
-Country-specific output sockets on request
J.T.O. SYSTEM, s.r.o.
Portable flammable gas detector GOFL
The GOFL detector is an instrument designed to detect the leakage of flammable gases into the air in a normal environment. Its main features advantages are easy operation, simple use, small size and good mechanical resistance. The instrument allows the setting of a concentration level, the exceeding of which is indicated by an uninterrupted beeping sound.
A catalytic sensor is used as the detection sensor, which responds to a wide range of combustible gases. The instrument is calibrated to methane as standard and, due to the known sensitivity of the sensor to other gases, allows switching between a methane value or a converted propane value. The instrument is equipped with a backlighted display which shows the current concentration value of the gas being detected. The value is displayed in units of \%LFL (percent lower flammable limit) and in units of ppm. The battery status is also indicated.
A battery is hardwired into the GOFL detector to power the instrument. Recharging of the internal battery can be done using a standard adapter with a USB-C connector.
COMET SYSTEM, s.r.o
IoT Wireless Four channel Datalogger with pulse and two-state inputs, with built-in 4G modem
TECHNICAL DATA
MEASURED VALUE
Two-state signal
Pulses
BINARY INPUT
Parameters of the voltage contact „L“ level input voltage:< 0,4 V(*);
„H“ level input voltage:> 2 V;
Minimum voltage applicable:0 V;
Maximum voltage applicable:+30 V DC
Parameters of the voltage-free contact Contact resistance in „switched-on“ state:< 10 kOhm;
Contact resistance in the „switched-off“ state:> 300 kOhm;
Contact voltage in the „switched-off“ state: ca 3 V;
Minimum state duration necessary for latching the state:1s
COUNTER INPUT
Counter parameters Range 24 bits (16 777 215), the possibility of letting the counter overflow
Maximum pulse frequency configured for voltage input - max. 5kHz
configured for a voltage-free or open-collector transistor - max. 200Hz
